Hello! Welcome to Beacon Tattoo Supply

Selected:

Infinite Irons Rolled Rear Shader Spring (.020” x 1.281” long)

$3.50

 

Infinite Irons Rolled Rear Shader Spring (.020” x 1.281” long)

$3.50

Infinite Irons Rolled Rear Shader Spring (.020” x 1.281” long) – These are the rear springs that Joey D. uses on his machines that have been sized to fit his liners and shaders

SKU: RRS-S20 Category:

Description

Infinite Irons Rolled Rear Shader Spring (.020” x 1.281” long) – These are the rear springs that Joey D. uses on his machines that have been sized to fit his liners and shaders. The spring length is 1 9/32 inches long overall and 1 23/32 inch from the a-bar screw hole center to the slot where an 8-32 screw will fit. It is also slotted at the rear to allow for a longer distance between screws. The spring width is 1/2 inch wide. Please measure carefully to figure the fit of your springs. This spring is commonly used on the following machines: The Saros shader, The Gearhead shader, The Eris shader, The Tattooer shader and The Keyhole shader. MEASURE CAREFULLY. MADE IN THE USA 

Additional information

Weight 0.0625 lbs
Quick Navigation
×
×

Cart